BMW & MINI ELV Steering Column LOCK Emulator CAS Repair Fix – from USA warehouse

QUALITY PRODUCT WITH UNLIMITED LIFETIME WARRANTY!
EQUIPPED WITH PERFECT FIT PLUG, ONLY PLUGS IN ONE WAY!

Offered item is an ELV emulator for the BMW E-series and also for Mini R55, R56 with electric steering lock.
The emulator simulates a perfectly working ELV for the CAS. Thus, no more check control message and the BMW starts again.

For CAS2, CAS3, CAS3+ Supported models: E70, E71, E72, E81, E82, E83, E84, E87, E88, E90, E91, E92, E93, E60, E61, E63, E64
and Mini R55, R56, 1 3 5 6 X1, X3, X5 series

This is the newest version! Advantages against other ELV emulators:


-Only plugs in one way. This eliminates the guesswork about pin connection. EQUIPPED WITH PERFECT FIT PLUG TYPE!
-Protective plastic case included, which protects item from short circuit, dust, condenstaion, mechanical damage.
-Longer connector cable which provides easier placement and installation.
-Compatible with 3 and 4 pin ELV modules too.

If the steering wheel lock on your BMW is mechanically faulty, the emulator can solve the problem cost effectively.
Ignoring the fault will lead to steering locking you out and resulting in a non-start of your car.
Of course, BMW Workshop wants to replace the complete steering column in this case.

The problem with ELV is known in the E81, E82, E87, E88, E90, E91, E92, E93, E60, E61, E63 and E64 models and also Mini R55, R56, X1, X3, X5 series.
Works also with the 1er BMW which only has 3 cables at the ELV.

Installation procedure is simple:

Remove trim panel under steering column (3 screws).
Disconnect the 3 or 4 pin plug from your ELV unit. That is located approximately in the middle of the steering column.

(If exists, Pin 4 is only a high current power line which powers the ELV module mechanical parts.
This is not used by the emulator, since it does not contains any mechanical parts.
So don’t worry, this emulator will be good for 3 and 4 pin ELV modules too.)

Plug the car connector onto the emulator and start the car.
After installation of ELV emulator, the vehicle has no more errors and starts normally.
Check if the message has disappeared.

It should be noted that in very rare cases a counter reset must be performed in the CAS control unit.
This requires a k +dcan INPA cable. Which you can buy from EBAY.
And additionally a software tool also needed. BMW tool32 for windows or Deep OBD for BMW (This is a free tool for Android phones. RECOMMENDED)
And some knowledge how to use above tools together. Not diabolical, you can google it 🙂

If you haven’t this tools or knowledge maybe this also helps to remove warning message after installation of the emulator:
Car will remove the error itself after 7-10 sleep cycle.
One sleep cycle: Drive the car about 1 minutes then lock the car, and leave it alone for 20 minutes.
Repeat the above cycle 7-10 times.

Or just normally use the car for some days after emulator installation, and the error warning will gone.

It wont fix your problem if you have a faulty CAS unit and/or the cable or plug is damaged or broken which leads from CAS to ELV unit!

THIS IS YOUR RESPONSIBILITY TO MAKE SURE YOUR CAS IS IN PERFECTLY WORKING CONDITION! PLEASE ASK BEFORE BUY, THIS IS NOT A TRY BEFORE BUY SERVICE.